Craftsman Digital Multimeter 82082 User Manual May 2026

AC/DC voltage, DC current, resistance, diodes, and continuity. Maximum Limits:

600V DC/AC, 200mA (standard port), and 10A (special fused/unfused port). Manual Ranging:

Unlike auto-ranging models, you must manually select the appropriate range on the dial to get an accurate reading. cdn.prod.website-files.com Setup and Basic Operation Probe Connection: Black Probe: Always plug into the (Common) jack. Red Probe: Plug into the craftsman digital multimeter 82082 user manual

jack for most measurements (voltage, resistance, low current). Use only for measuring high DC current (above 200mA). Selecting a Function: Turn the rotary dial to the desired mode (e.g., for DC voltage, for AC voltage). Selecting a Range:

Choose a range higher than the expected value. For example, use the setting to test a 120V household outlet. Common Measurements How to Measure Resistance with a Multimeter LCD Display: 3½ digits (max reading 1999)

2. Meter Components (Refer to your physical unit)

  1. LCD Display: 3½ digits (max reading 1999). Shows value, polarity (-), low battery (BAT), and over-range (OL).
  2. Range Selector Dial: 9 positions for functions.
  3. Hold Button: Freezes the current reading on screen.
  4. 10A Jack: Red lead – for high current (up to 10A).
  5. VΩmA Jack: Red lead – for voltage, resistance, continuity, diode, and low current (<200mA).
  6. COM Jack: Black lead – common ground for all measurements.

5. Detailed Operating Instructions

7. Maintenance: Battery and Fuse Replacement

The Craftsman 82082 requires minimal but critical maintenance.

When to replace the battery: The display dims, the low battery icon appears, or readings become erratic. Insert black lead into COM

Step-by-step battery replacement:

  1. Set the dial to OFF and remove test leads.
  2. Use a small Phillips screwdriver to remove the screw on the battery cover (lower back of unit).
  3. Remove the old 9V battery. Snap the new 9V battery onto the connector.
  4. Replace the cover and screw.

Fuse replacement (if meter cannot measure current):

  • The 82082 typically contains two fuses: one for the mA range (often 200mA/250V) and one for the 10A range (10A/250V).
  • Open the main body (not just battery cover) by removing the two screws on the back case.
  • Gently lift the circuit board to access fuses.
  • Only replace with identical fuses (fast-blow ceramic of the same rating). Using a different fuse is a fire hazard.

5.4 Continuity Buzzer Test

This is a quick "go/no-go" test for fuses, wires, and switches.

  1. Insert leads into COM and V/Ω.
  2. Turn dial to the Continuity symbol (often a sound wave or diode symbol next to a small speaker icon).
  3. Touch probes together. You should hear a clear, steady beep.
  4. Touch probes across the circuit (e.g., a fuse). A beep = good continuity (0-50 ohms). No beep = open circuit.

Report: Craftsman Digital Multimeter Model 82082 – User Manual Overview

Prepared For: General Reference / Users of Craftsman 82082
Document Type: User Manual Analysis & Summary
Date: [Current Date]

Measuring AC/DC Voltage

  1. Insert black lead into COM, red lead into V/Ω.
  2. Turn dial to DCV (V with straight line) or ACV (V with wavy line).
  3. Select a range higher than the expected voltage.
  4. Touch probes to the test points (parallel connection). Read the value on the display.