Epson L6490 Adjustment Program Top Guide

Here’s a concise review of the Epson L6490 Adjustment Program (often searched as “top” or “latest version”), based on common user experiences and technical support forums.

Final Verdict: Is the Adjustment Program Top Worth It?

Absolutely – if you are out of warranty.

Epson designs these counters for "planned obsolescence" after roughly 15,000 to 20,000 A4 prints. The official service center fee (labor + pad replacement) typically runs $120–$180. epson l6490 adjustment program top

The Epson L6490 Adjustment Program Top costs you nothing but 20 minutes of your time. Combined with a $10 waste ink bottle mod, your L6490 will run for 200,000+ prints without ever seeing a fatal error again.

Your action plan:

1. Download the Top version from a verified source.
2. Physically inspect/clean your waste pads.
3. Enter service mode carefully.
4. Reset both counters.
5. Exit and enjoy your revived EcoTank.

Pro tip: Back up your printer’s EEPROM before resetting (the Top tool has a “Backup” button). Save that .bin file to your cloud. If something goes wrong, you can restore the original factory settings instantly.

Step-by-Step Guide: How to Reset the Epson L6490 Using the Top Adjustment Program

Before starting, understand this: Using third-party adjustment programs may void your Epson warranty. Proceed at your own risk. Here’s a concise review of the Epson L6490

Step 2: Connect & Enter Service Mode

This is the most critical part. The printer will not respond to the adjustment program unless it’s in Service Mode:

1. Turn off the printer (use the power button, then unplug for 10 seconds).
2. Plug the printer back in, but do not turn it on.
3. Hold down the "Stop" button (red circle/triangle) AND the "Power" button simultaneously.
4. Keep holding both. After 5 seconds, release the "Power" button but keep holding the "Stop" button for another 5 seconds.
5. Release the "Stop" button. The LCD screen will go blank, and all lights may flash. Congratulations – you are in Service Mode.

Physical Maintenance: Do Not Just Reset – Clean!

The Adjustment Program resets the counter, not the physical pad. If you run the reset without addressing the actual waste ink: Download the Top version from a verified source

• The pads will eventually saturate.
• Ink will leak out of the printer’s bottom, ruining your desk and potentially shorting the power supply.

Best Practice:

1. Open the L6490 (remove the scanner unit – watch a disassembly guide).
2. Locate the two waste pads (under the printhead capping station and right side platen).
3. Either replace them with genuine Epson pads (Part #: 1644168) OR install a waste ink bottle kit (external modification).
4. Then run the Adjustment Program Top to reset the counter.