Landis Gyr E360 User Manual ((link)) May 2026

Landis+Gyr E360 — Informative Overview

1. Safety Information

WARNING: HAZARDOUS VOLTAGE INSIDE.
Installation and removal must be performed only by qualified utility or licensed electrical personnel.

• De-energize the meter socket or panel before connecting/disconnecting the meter.
• Do not use the meter if the cover is cracked or broken.
• The E360 is for indoor or outdoor weather-protected locations (NEMA 3R / IP54 depending on variant).
• Always observe local wiring codes (NEC, CEC, or local utility standards).

Legal and Safety Compliance – A Note from the Manual

The Landis Gyr E360 must be installed and serviced only by licensed electricians or utility personnel. The user manual repeats this warning in bold text: “This meter is not user-serviceable. Opening the meter seals voids the warranty and may constitute fraud.” landis gyr e360 user manual

In addition, the manual includes regional disclaimers. For example, in the EU, the E360 complies with the Measuring Instruments Directive (MID 2014/32/EU). In North America, it carries ANSI C12.20 certification. Landis+Gyr E360 — Informative Overview 1

4. Programming and Configuration

This is the most technically dense part of the manual. Non-utility personnel typically cannot change calibration constants, but you can adjust communication parameters. Using the optical port (IEC 62056-21 / FLAG protocol), you can: Legal and Safety Compliance – A Note from

• Set the meter’s Modbus or DLMS/COSEM address
• Configure baud rate (default 9600 or 19200)
• Reset maximum demand registers

Warning: The manual clearly states that calibration and security keys are protected by utility passwords. Attempting to bypass these may void the warranty.

9. Maintenance and Disposal

Unlike electromechanical meters, the E360 requires no routine mechanical maintenance. However, the manual recommends:

• Annual visual inspection for moisture or corrosion.
• Cleaning the optical port with a dry cloth.
• Disposal in compliance with WEEE (Waste Electrical and Electronic Equipment) regulations – do not throw in general trash.

Chapter 3: Navigating the LCD Display (The "Scrolling" Mode)

The most common reason users search for the Landis Gyr E360 user manual is to understand what the blinking numbers on the screen mean. By default, the meter scrolls through preset display modes (Mode A, Mode B, Mode C).

14. Advanced tips for power-savvy users

• Use the meter’s instantaneous kW readout to do a “load inventory”: turn off all breakers and enable them one-by-one while watching the meter to map loads to consumption.
• For buildings with large motors, monitor inrush events via the meter’s log or power quality data to identify motor-start issues.
• For troubleshooting intermittent faults, correlate meter event timestamps with device or inverter logs.

Required Tools (as listed in the manual):

• Flathead and Phillips screwdrivers
• Torque wrench (for terminal screws – specific torque values are on the meter label)
• Voltage tester
• RJ45 or optical probe for programming

Common capabilities for utilities and users

• Automated meter reading (AMR) and full advanced metering infrastructure (AMI) integration.
• Remote disconnect/reconnect (utility-controlled, subject to local regulations).
• Outage detection and restoration events reporting.
• Real-time or near-real-time consumption feedback for demand response programs.
• Support for customer portals via utility back-end to view interval usage, bills, and alerts.