Point-n-measure Digital Tape W5746 User Manual Updated -
Since I cannot physically hand you a piece of paper, I have reconstructed the standard user manual content for this specific tool below. This guide covers the features, instructions, and troubleshooting for the Point-N-Measure tape measure.
3. Device Diagram (Key Features)
| Callout | Component | Function | | :--- | :--- | :--- | | 1 | Laser Aperture | Emits the laser beam. | | 2 | LCD Display | Shows measurement, battery level, and unit. | | 3 | Power/Measure Button | Turns unit ON and takes a measurement. | | 4 | Reference Button | Switches measurement from back of tool to front. | | 5 | Unit/Function Button | Changes between ft/in, decimal feet, and meters. | | 6 | Battery Door | Located on back; holds 2x AAA batteries. | | 7 | Belt Clip | Attaches to pocket or tool belt. | Point-N-Measure Digital Tape W5746 User Manual
(Insert product image here if applicable) Since I cannot physically hand you a piece
3. Unpacking and Components
Upon unpacking, ensure all items are present: Cleaning the Optics:
- W5746 Laser Measuring Tool
- 2 CR2032 Batteries (pre-installed)
- USB Charging Cable
- Stylus (for screen interaction)
- User Manual
Key Parts:
- Laser Key – Activates the laser for distance measurement.
- Display Screen – Shows measurements, modes, and battery status.
- Mode Button – Switches between measurement units (meters/feet) and modes (distance, area, volume).
- Power Button – Turns the device on/off.
- Memory Button – Stores/retrieves saved measurements.
10. Troubleshooting
| Issue | Solution |
|-------------------------------|----------------------------------------|
B. Key Features
- Dual Measurement: Switch between Laser Mode and Tape Mode.
- Multiple Units: Meters (m), Feet (ft), and Inches (in).
- Calculation Modes: Single distance, Area, and Volume.
- Auto-Correction: Automatically calculates Pythagorean measurements (indirect measuring).
- Data Hold: Freezes the measurement on the screen.
Indirect Measurement (Indirect Distance Calculation via Pythagoras):
- For inaccessible heights, measure two adjacent sides.
- Press Mode Button into "Indirect Mode."
- Input side lengths; the tool calculates the distance.
4. Getting Started
- Insert/Replace Battery:
- Open the battery compartment.
- Insert 2 CR2032 batteries (observe polarity markings).
- Power On: Press and hold the Power Button until the screen displays.
4.1 Installing Batteries
- Slide the battery cover downward to open.
- Insert 2x AAA batteries matching the polarity (+/-) indicated.
- Snap the cover back into place.
Cleaning the Optics:
- Use a microfiber cloth to gently wipe the laser emitter and receiver lenses.
- Never use alcohol, acetone, or abrasive pads. These will cloud the plastic lens.