Videojet 1280 Manual Pdf Install May 2026

How to Find & Use the Videojet 1280 Manual PDF for Installation

If you’ve just purchased a Videojet 1280 (or are maintaining an existing one), you know it’s a powerhouse in the continuous inkjet (CIJ) world. But before you start printing expiration dates or lot codes, you need to get it set up correctly.

The official Videojet 1280 manual PDF is your best friend during installation. Here is everything you need to know about finding the right document and the key steps for setting up this industrial printer. videojet 1280 manual pdf install

1. Unpacking & Inspection

• Verify all components: printer head, control unit, stand (optional), ink bottle, makeup bottle, and fluid tubes.
• Check for shipping damage before signing any delivery receipt.

Maintenance & consumables

• Keep spare printheads, filters, and approved ink stock.
• Follow the manual’s preventive maintenance schedule: periodic head cleaning, filter changes, and fluid replacements.
• Record service intervals and print counts.

What you’ll need

• Videojet 1280 printer
• Power cable and compatible mains outlet
• USB or Ethernet cable (as applicable to your setup)
• PC with Windows (or other host) and required drivers/software
• Printhead mounting hardware and brackets for your production line
• Ink/fluids specified for Videojet 1280
• Safety gear (gloves, eye protection) and spill supplies
• The official Videojet 1280 installation manual (PDF) — follow it for safety/ warranty-critical steps

Step 4: Electrical and Grounding

The installation manual dedicates two full pages to grounding. How to Find & Use the Videojet 1280

• Test the outlet: Use a socket tester to ensure ground integrity.
• Printer grounding lug: If using a static-prone substrate (e.g., plastic film), attach a separate grounding wire (12 AWG) from the printer’s rear grounding stud to a known earth ground.
• Avoid VFDs: Do not route the power cable near variable frequency drives (VFDs) on conveyors.

Electrical & network connections

1. Connect power cable to printer controller and to mains; don’t power on yet if manual requires a specific sequence.
2. Connect printhead(s) to the controller using the provided cable(s).
3. Connect USB or Ethernet to the host PC or factory network. Configure static IP if required (manual will show network menu steps).
4. If using I/O signals (start/stop, detect), wire them following the I/O diagram in the manual.

2. Fluid Handling (The "Bottle Swap")

Unlike smaller printers, the 1280 uses a bag-in-box system. Verify all components: printer head, control unit, stand

• The Manual shows: How to connect the make-up bottle (low viscosity) and the printer bottle (ink).
• Critical Step: You must remove the shipping bracket (page 24 of most versions) before turning on the pump. If you miss this, the pump will stall.